Installation - Crosley XCM16SMWW Manual Del Propietário

Preparing of Installation
Read these instructions completely and carefully.
Freezer Location
Your freezer should be conveniently located for
day-to-day use in a dry, well-ventilated room .
Do not install the freezer where the temperature will go
below 0°F (-18°C) or above 110°F (43°C), because it will
not maintain proper temperatures .
Level Freezer
Level the freezer from side to side and front to back
so that the lid will seal properly . Use shims to level the freezer if necessary .
Clearances and Ventilation
Allow at least 2" (50.8 mm) clearance on both sides of
the freezer and 2" (50.8 mm) between the back of the
freezer and the wall . Leave room above the freezer to
open the lid .
Keep flammable materials and vapors, such as gasoline, away from freezer .
Lid Removal
CAUTION
LIFTING HAZARD
The lid is heavy . Use both hands to secure the lid before
lifting .
CAUTION
HINGE SPRING UNDER TENSION
If it is necessary to remove the lid, follow these steps:
1 . Remove the lower part of the hinge cover and then
remove the upper part .
10
Do not install the freezer in a location exposed to rain
water or direct sunlight .
Be sure to install your freezer on a floor strong enough
to support it when it is fully loaded .
NOTE: It should not be necessary to remove the lid
during installation . If, for some reason, the hinges need adjustment, call a professional service company .
Do not cover the freezer with items such as blankets,
sheets, tablecloths, etc . This reduces air circulation .
2 . Open the lid to the maximum position . (The hinges are
loosest at this position .)
3 . Remove the 4 screws from the upper part of the hinge
and lid . Do this for each of the hinges .
Upper Hinge
Cover
Lower Hinge
Cover
4 . To reinstall lid follow steps in reverse . Tighten all
hinge screws but avoid over-tightening to prevent
stripping . Reinstall hinge covers .
Hinge Screws to
be Removed
49-1000112 Rev. 0