Idiomas disponibles
Idiomas disponibles
JUNO IC1RLWD REMODEL RECESSED HOUSINGS
ELECTRICAL CONNECTION
INSTRUCTIONS
Step 1. Provide electrical service according to
national and/or local electrical code to the junction
box located on the remodel housing. Supply wire
insulation must be rated for at least 90°C. Note:
this fixture requires a flexible electrical supply.
Step 2. Remove junction box cover. Remove the
appropriate knock-out(s) to accommodate the
type of electrical supply being used. (Fig. 5)
Flexible Metal Conduit. Remove appropriate
round knock-out(s) and connect conduit to
junction box with proper connectors (not
supplied).
12/2 or 14/2 Non-Metallic Sheathed Cable
(Type NM-B). Remove appropriate D-shaped
cable knock-out(s). Insert the NM-B cable through
the cable trap and make a 90˚L-shaped bend in
cable as shown (Fig. 6).
12/3 or 14/3 Cable (Type NM-B). Remove the
appropriate round knockouts and connect cable
with proper electrical connectors (not supplied and
not shown).
Knock-out
LED Driver
Quick Connector
Figure 5
WARRANTY
Juno Lighting Group provides five year limited warranty on LED components from date of purchase. Juno Lighting Group's obligation is
expressly limited to repair or replacement, without charge, at Juno Lighting Group's factory after prior written return authorization has been
granted. This warranty shall not apply to products which have been altered or repaired outside of Juno Lighting Group's factory. This warranty
is in lieu of all other warranties, expressed or implied, and without limiting the generality of the foregoing phrase, excludes any implied warranty
of merchantability. Also, there are no warranties which extend beyond the description of the product on the company's literature setting forth
terms of sale.
Product Services Phone (888) 387-2212
1300 South Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068 • www.junolightinggroup.com
INSTALLATION INSTRUCTIONS
Step 3. Strip supply wire 3/8" and insert each
supply wire into appropriate connector. Connect
black fixture wire to hot, white fixture wire to neutral
and green fixture wire to ground. (Fig. 5).
Step 4. Place all wiring and connectors back in
wiring box and replace cover, taking care not to
pinch any wires.
NM-B Cable
Knock-out
(Oval Shaped)
NM-B Cable
NM-B Cable
Trap
(4 Places)
12/2 or 14/2 NM-B Installation
Figure 6
© 2014 Juno Lighting LLC
Rev 5/14
P5943
pg 2 of 2
