Idiomas disponibles
Idiomas disponibles
ALARM LED CODES
If you have an alarm and optional LED(s) installed, it will flash once
a second if armed. If your alarm is triggered then the LED(s) will flash
more than once until it is disarmed. See the table below for what
each LED code represents.
ALARM TRIGGER EVENT
Door, Hood, Trunk, or Ignition On triggered
Full triggered shock sensor
Optional sensor triggered
Panic Mode
Valet Mode: If your remote start is not working, you may be in Valet
Mode. Your parking lights will also not flash. Your doors will still
lock and unlock. To exit Valet Mode, tap the Lock and Trunk buttons
or turn the Ignition On and then tap the foot brake 10 times or
reprogram your remote(s).
To reprogram your remote first cycle the key in the ignition 5 times
within 7 seconds. Parking lights will flash. After that tap the Lock
button on your remote. Repeat for any additional remotes. If you
receive two parking light flashes, your system has exited remote
programming mode and you must retry.
QUICK START CARD
LED FLASHES
2, Pause, Then Repeat
3, Pause, Then Repeat
4, Pause, Then Repeat
5, Pause, Then Repeat
1 WAY 4 BUTTON REMOTES
START ERROR CODES
PARKING LIGHT FLASHES
3 then 1
3 then 2
3 then 3
3 then 4
3 then 5
3 then 6
3 then 7
3 then 8
3 then 9
3 then 10
Register online at www.compustar.com within 10 days of
purchase to activate your new remote's warranty.
Questions/comments? Contact us at 888-820-3690 from 8
AM to 5 PM PST. Also please visit www.compustar.com for a
complete user's manual.
REMOTE START ERROR
1: Motor running
2: Key in ignition on position
3: Door open
(manual transmission only)
4: Trunk open
5: Foot brake on
6: Hood open
7: Reservation off
(manual transmission only)
8: Tach or voltage sensing failure
9: FT-DAS sensor shutdown
10: System is in Valet Mode
Firstech, LLC. | 2
