Uline H -1217 Manual Del Usuario

π
H-1217
RATCHET TIE-DOWNS
1. Fully engage end hooks so that a secure tie down
point rests against the base (Bearing Point) of the
hook. Never load tip of hook.
NOTE: Handle must always be in line with
direction of pull to achieve Working Load
Limit. (See Figure 1)
2. Insert free end of strap through mandrel slot in
ratchet and pull through until strap is snug around
the load. (See Figure 2)
3. If handle is closed and locked, pull on the Lock
Release Handle to disengage. (See Figure 3) Then
tighten strap by pumping the handle until strap is
tight. (See Figure 4)
NOTE: A minimum of two wraps of webbing
around the mandrel is required.
4. Lock ratchet assembly by pulling on Lock Release
Handle and pushing main handle until fully closed.
5. To release tension or remove tiedown, pull on Lock
Release Handle and rotate main handle 180° to
lock in the open position. Mandrel will be free to
turn and release webbing. (See Figure 5)
Figure 1
Bearing Point
of Hook
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com
USAGE INSTRUCTIONS
Para Español, vea página 2.
Figure 2
Lock Release
Handle
Figure 4
Figure 3
Figure 5
1013 IH-1217