Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ENGLISH
PROBLEM
The level of
humidity shown
on the screen is
not correct
The control panel
does not work
A white powder
appears around
the humidifier
Mist comes out of
the base
Mist comes out
around the nozzle
6. MAINTENANCE
In order to always keep the product clean:
∙ Use purified water.
∙ Regularly clean the base of the unit, the water tank, and the transducer accordi
∙ Always change the water in the water tank with clean water every day, in the event
that it has not all been used during normal operation.
∙ Always empty the water tank when it is not being used.
CAUSE
The room is too large
Humidity has accumulated
inside the humidity sensor
The nozzle is pointing
toward the humidity sensor
The humidity sensor is
broken or faulty
You are trying to operate
the control panel with wet
hands
The humidifier does not
work properly
The water used has a high
mineral content
The humidifier was not
cleaned properly after its
last use
The water tank is not
properly positioned
There are openings
between the nozzle and
the water tank
SOLUTION
Place the humidifier in a more
adequate room
Switch off the humidifier and
leave the humidity sensor to air
dry before using it again
Twist the nozzle so that it points
toward the opposite side to the
humidity sensor
Contact the Miniland technical
service staff
Dry your hands before
operating the control panel
Contact the Miniland technical
service staff
Use distilled water in the
humidifier. If you do not have
distilled water, use purified or
filtered water. Remember to
clean the water tank at least
once a week
Clean the humidifier according
to the instructions in the
Cleaning section
Switch the humidifier off and
unplug it. Then line the water
tank cover up correctly in its
respective opening
Put the cover back on and
check whether the nozzle is
correctly positioned
20
Tabla de contenido
