Extension Cords; Backer Pad/Dust Skirt Installation - USand BT700 Manual Del Operador

EXTENSION CORDS

Use only 3-wire extension cords that have 3-prog grounding-type plugs and 3-pole cord connectors that
accept the plug from the product. Use only extension cords that are intended for extra-hard service.
These extension cords are identified by a marking such as "S, SO, ST, or STO". Use only extension cords
having an electrical rating no less than the rating of the product. DO not use damaged extension cords.
Examine the extension cords before using, and replace if damaged. Do not damage the extension cord
and do not pull on any cord to disconnect. Keep the cord away from heat and sharp edges. Always
disconnect the extension cord from the receptacle before disconnecting the product from the extension
cord.

BACKER PAD/DUST SKIRT INSTALLATION

1. Use ¾" open end wrench to hold lower shaft and turn backer pad clockwise to install.
2. HAND TIGHTEN ONLY!
3. Set machine upright on floor.
4. Attach the removable part of the dust skirt (US115-146) to the lower part of the deck plate so
that the skirt just touches the floor. (if not properly installed the vacuum system may not
operate to its full potential).
6