Installation Instruction; Parts List - Heat Storm 23II200GRA Manual De Operacion Del Propietario

Position your completed mantel close to its
final location. Make sure you can access the back of
the mantel as your Electric Fireplace Insert will be
installed from the back.
Using a Phillips head screwdriver, remove the screws
and the metal mounting brackets attached on either
side of the fireplaces center opening. Next unpack
the Electric Fireplace Insert carefully. Position the insert
behind the fireplace with front facing the wood mantel.
With the help of an adult assistant, lift the Insert and
gently slide it into the opening in the mantel until the
flange is flush against the inside of the mantel. Make
sure insert is centered left and right in the opening. Be
careful when placing insert and adjusting, bottom of
insert could scratch the finish of the base/hearth
of your fireplace. Re-attach the mounting brackets
with the Phillips head screwdriver, and supplied
screws. DO NOT OVER TIGHTEN.
With the help of an assistant, carefully lift completed
unit and place it with the front facing out in the final
location you have chosen for your fireplace.
Part Name
Emberbed
Blower Assembly
Infrared Heater Assembly
Control Panel - 6 Buttons
Main PCBA
Control Panel Circuit Board
Front Projection Screen
Flame Generator Drive Motor
Flame Generator/Spinner
Decorative Brick Panels
Remote Control - 6 Buttons
All manuals and user guides at all-guides.com

INSTALLATION INSTRUCTION

PARTS LIST

Make sure to secure the electrical cord before lifting
or moving completed fireplace. When choosing a final
location, make sure you will have clear access to a
grounded electrical outlet.
Read and follow all instructions in this manual before
operating your new fireplace.
INSERT
MOUNTING
BRACKET
ELECTRIC
FIREPLACE
INSERT
E-3
Figure 2
REAR VIEW OF FIREPLACE
23II200GRA