Maintenance; Troubleshooting - Marshalltown SPNRSSAGAS Manual Del Usuario

After each use, ensure the Spin Screed® is cleaned and stored carefully. Find a
secure location for the Pipe to prevent any objects from falling on or damaging it.
After every three to four uses, lubricate the Dead End Pipe Adapter through the
grease fitting using a standard lever-action grease gun.
Prior to starting the engine, add engine oil at the fill port at the base of the engine.
THE ENGINE WAS SHIPPED WITHOUT OIL IN THE CRANKCASE. A small bottle is
included with the product which corresponds with the precise amount needed.
Retain the bottle for future measuring purposes.
Following first 20 hours of run time replace the engine oil. The oil is drained by
removing the drain plug from the base of the engine and tipping the engine.
Fill only the amount recommended by engine manufacturer — DO NOT OVERFILL
THE ENGINE.
Engine oil is to be replaced after every subsequent 40 hours of use.
Check sponge air cleaner by squeezing the plastic intake cover catches and pull
it off. The air cleaner can be rinsed with water. Be sure to squeeze out as much
water as possible prior to replacing.
The gearbox is delivered fully greased. After approximately 40 hours use it is
recommended that the user inject NLGI #0 Lithium Grease into the zerk mounted
on the side of the gearbox. The drain screw must be removed to allow old grease
to escape. Be sure to replace drain screw when finished.
Repeat grease replacement every 40 hours.
If the Spin Screed® is not spinning or functioning properly, refer to the following guide to diagnose and resolve your issue.
• Refer to Honda GX35 owner's manual for engine troubleshooting.
• Check if the end plugs are fully tightened. Tighten them if required.
WS2860
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com

MAINTENANCE

TROUBLESHOOTING

PARTS AVAILABLE FOR REPLACEMENT
ITEM
Dead End Pipe Adapter
Live End Pipe Adapter
Power Head*
Pipe**
Quick Disconnect Pin
Dead End T Handle
Gearbox, Gas Screed, Replace
Throttle Lever Replace
Engine Switch Replace
Axle Assembly Replace
PTO Cover Replace
Throttle Cable Replace
*Handle & Motor enclosure with Power Head **Pipe available from 4' to 22' in even numbers
PART#
SPNDE
SPNLE
SPNRSSGAS
SPNP4 – SPNP22
SPNQDP
SPNDH
29588
29589
29590
29591
29593
29594
Drain
Plug
Zerk
Drain
9 of 10