Giroo Heli 3.5CH R/C Manual De Usuario página 17

Product component (Aircraft illustration)
Canopy
Head Light
Installation of Remote Controller
Instal the antenna. Insert the antenna
into the top small hole of the controller,
then slightly press and spin the antenna
clockwise. (as shown)
Install the battery. Open the battery com-
partment. Load 6 X 1.5V size AA batteries
as the polarities shown, then close the
battery cover properly. (as shown)
Please assure the polarity
when loading the battery.
Please do not use mixed
types of batteries.
Do not use new and used
batteries in mix
Charging method for helicopter power
Charging the helicopter with provided adapter.
Turn off power switch of helicopter, connect adapter core to
charging slot of helicopter,then plug the adapter into power outlet.
When charging, the red light on the adapter will turn on
The 3.7V adapter is suitable for Model No 505/503/
507, after charging about 120-150 minutes, the green indicator
will turn on, charging completes. The 7.4V adapter is suitable
for Model No.703/705/707, after charging about 120-150
minutes, the green indicator will turn on, charging completes
Please disconnect the adapter in time after charging finished.
Caution
Balance Bar
Main Shaft
Stop Collar
Fuselage
Covering
Horizontal Tail
Alloy Supporting
Pipe
Landing Skid
Left Control Lever
Speed transition
- 17-
Main Blade A
Main Blade B
Alloy Tail Shaft
LED Light
Vertical Fin
Antenna
Power Light
Right Control Lever
(Forward/Backward,
Left/Right Turn)
Power Switch Trim-
mer Button
Light Control
Install and spin
clockwise
uses 6x1.5V size
"AA" batteries (not included)
Tail
Rotor
Tail Motor
Stand