Enlaces rápidos

This manual describes the installation and operation of the Model S273E/EP non-catalytic wood heater.
This heater meets US Environmental Protection Agency's emission limits for wood heaters. Under
specific conditions this heater has been shown to deliver heat at rates ranging from 10,370 to 29,301 BTU
per hour.
Model No. S273E/EP
This unit has been listed by Warnock
Hersey Limited to meet or exceed
ULC S-627 Canada and UL 1482 U.S.
Contact your local building inspector
prior to installation.
A permit maybe required in your area.
2ft(635mm) HIGHER THAN
3FT(1M) MIN
NEAREST POINT OF
ROOF WITHIN 10ft(3M)
FROM ROOF
PENETRATION
MINIMUM OVERALL
G
HEIGHT FROM FLOOR
15FT(5M)
Unit must be placed on a noncombustible floor protection equivalent to 3/8" millboard.
Floor protector must have min. R value of .893
Consult your local building authorities for further information.
HANDLE
Twist spring handle
SPRING
in counter
clockwise motion while pushing on to handle;
spring handle will "thread" down to desired
location.
Desired Burn Setting
Low
Med / Low
Med / High
High
**Performance may vary depending on actual home operating conditions
MADE IN CANADA BY CFM Corporation, 410 Admiral Boulevard, Mississauga, ON L5T 2N6
NOTE: Retain this sheet for future reference
6" Flue Required
Figure A: Clearance from combustible constructions
A minimum clearance of 18" (457mm) to the chimney connector
may be required by the authority having jurisdiction.
From Heater
From Chimney Connector
A
Sidewall.........17-1/2" (444 mm)
D
Sidewall...................... 28" (711 mm)
B
Backwall...............13" (330 mm)
E
Backwall................15-1/2" (394 mm)
C
Corner...................11" (279 mm)
F
Corner..........................22" (381 mm)
G
Ceiling....................54-1/2" (1384 mm)
BACK WALL
B
E
8"(203mm)
A
D
*16
**18
C
8"(203mm)
8"(203mm)
Figure "A"
*16"(406mm) U.S.A.
**18"(457mm) Canada
CAUTION: Do not open fire-door to a point where it
would be in contact with the combustible sidewall.
BE SURE TO INSTALL TWO
FULL BRICKS (S16040) IN
BAFFLE AS SHOWN
OPTIONAL FAN
An optional heat exchange blower is available for
2 FULL BRICKS
this wood burning appliance. To order please see
the local dealer where you purchased your appliance.
BAFFLE ASSEMBLY
CAUTION: BRICK FOR ASH DRAWER
MUST BE INSTALLED BEFORE
OPERATION OF WOOD HEATER
Inlet Air Control Settings
Inlet Air Setting
**Approx. BTU Output
Closed Fully
10,370
¼ Open
12,420
¾ Open
15,676
Fully Open
29,301
800-668-5323
Part No S19219 Rev08
10
12
11
BACK WALL
16
C
F
14
13
13
F
Disposition Des Briques
Diseño de colocación de los ladrillos
ITEM NO.
NO.
LEYENDA NO.
1
DOOR ASSEMBLY
1
DOOR - NO GLASS
2&3
GLASS AND GASKET
3
1/8" GLASS GASKET
4
5/8" DOOR GASKET
5
SPRING HANDLE
6
AIR CONTROL SPRING HANDLE
7
8
9
10
11
12
13
FIREBRICK LT 9"x4-7/16"x1-1/4"
14
FIREBRICK LT 7-1/4"x4-7/16"x1-1/4"
15
FIREBRICK LT 4-1/2"x4-7/16"x1-1/4"
16
FIREBRICK LT - ANGLED
17
FIREBRICK LT 8"x4-7/16xx1-1/4
www.cfmcorp.com
5
2
1
16
14
14
14
13
13
13
13
17
13
15
13
Brick Pattern
PARTS LIST
LISTE DES PIÉCES
DESCRIPTION
DESCRIPTION
PORTE MONTÉE
PORTE - SANS LA VITRE
VITRE DE JOINT D'ÉTANCHEITÉ
JOINT DE LA VITRE 1/8po
JOINT DE LA PORTE 5/8po
POIGNÉE À RESSORT
POIGNÉE POUR L'ADMISSION D'AIR
GLASS CLIP
FERRURE POUR LA VITRE
GLASS CLIP
FERRURE POUR LA VITRE
NUT
ÉCROU
HINGE PIN
GOUPILLE DE CHARNIÈRE
PUSH NUT
ÉCROU À RESSORT
INLAY
GARNITURE DE LA PORTE
BRIQUE 9"x4-7/16"x1-1/4"
BRIQUE 7-1/4"x4-7/16"x1-1/4"
BRIQUE 4-1/2"x4-7/16"x1-1/4"
BRIQUE - COUPLÉE EN ANGLE
BRIQUE 8"x4-7/16"x1-1/4"
4
3
7
9
8
6
QTY
PART NO.
LISTA DE PIEZAS
QTÉE
NO.de PC
CANT. ART NO.
DESCRIPCIÓN
UNIDAD DE PUERTO
1
S31103
1
UNIDAD DE PUERTO SIN VIDRIO
S41075
VIDRIO Y EMPAQUETADURA
1
S31128
EMPAQUETADURA DE 1/8" PARA EL VIDRO
4.0'
S15001
EMPAQUETADURA DE 5/8" PARA LA PUERTO
4.5'
S15011
MANGO CON RESORTE
1
S11007
MANGO CON RESORTE PARA EL REGULADOR DEL AIR
1
S11008
PRESILLA PARA EL VIDRIO
2
S37020
PRESILLA PARA EL VIDRIO
1
S37021
TORNILLO
7
S11018
DEPIENDA ALFILER
2
S11005
UNIDAD DEL DEFLECTOR
2
S11090
MOLDURA DE LATÓN PARA EL CUERPO DEL CALEFACTOR
1
S13144
S16040
LADRILLO REFRACTARIO 9"x4-7/16"x1-1/4"
12
LADRILLO REFRACTARIO 7-1/4"x4-7/16"x1-1/4"
4
S16043
LADRILLO REFRACTARIO 4-1/2"x4-7/16"x1-1/4"
1
S16046
LADRILLO REFRACTARIO - ANGULADO
S16042
2
LADRILLO REFRACTARIO - 8"x4-7/16"x1-1/4"
1
S16138
loading

Resumen de contenidos para Century Hearth S273E

  • Página 1 Part No S19219 Rev08 NOTE: Retain this sheet for future reference This manual describes the installation and operation of the Model S273E/EP non-catalytic wood heater. This heater meets US Environmental Protection Agency’s emission limits for wood heaters. Under specific conditions this heater has been shown to deliver heat at rates ranging from 10,370 to 29,301 BTU per hour.
  • Página 2 NOTA: Conserve este hoja para consultaria en el futuro NOTA: Gardez cette feuille pour consultation future. Este manual describe la instalación y el funcionamiento de los modelos S273E/EP de los Lire avec soin les instructions suivantes avant d’installer le poêle Modèle S273E/EP non catalytique.

Este manual también es adecuado para:

S273ep