Troubleshooting; Replacement Parts; Specifications - Renaware Aqua Nano UCU LX-200 CAL Uso Y Mantenimiento

Idiomas disponibles

Idiomas disponibles

Troubleshooting

1.
Water is not coming out of the spout...
• Make sure the source water valves are turned on.
• Make sure the tubing is smooth and straight, without kinks.
• Remove the areator and make sure it is not blocked by any residue.
2.
Water leaks out from between the filter cartridges or at the filter inlet
assembly or filter base...
• Separate the cartridges at the point of the leak. Each of the cartridges, and the
filter inlet, should have two o-rings on the raised outlet found between the three
feet. Check to ensure that the o-rings are in place and properly seated in the
grooves provided for them.
3.
Water leaks from the tubing...
• Check the tubing for cuts or nicks. Check to ensure that the o-rings in the 3-way-
valve and in the Braided Source Water Tube are in place and properly seated.
4.
Water continues to flow out of the Spout after water is turned off...
• Water may continue to flow from the Spout for a short time due to a build-up of
pressure within the filter but will typically stop by itself.
• Trapped air in the filter may force water out after the tap has been turned off. To
eliminate the trapped air, fill the Cartridges with water until you see water leaking
through the top hole of the Cartridges. This is known as "charging" the cartridge
and is done manually with the inlet assembly removed from the top of the filter
cartridge. See "Charging the system".
5.
Lights on the Faucet Collar do not work . . .
• Make sure that the Data Cable is properly plugged into the Data Port.
• Check batteries.
22
22

Replacement Parts

NOTE: Always use genuine Rena Ware replacement parts.
Contact your Rena Ware Independent Representative or the Rena Ware Customer Ser-
vice Center near you to order replacement parts for your Aqua
may also visit Rena Ware on the worldwide web at www.renaware.com for information
on our Service Centers and products.
NanoCeram® Cartridge
Pre-Filter Housing
EM Media
Insert

Specifications

Aqua
Nano
Maximum Operating Pressure
Minimum Operating Pressure
Maximum Water Temperature
Minimum Water Temperature
Filtered Water Flow Rate @ 60 psi
NanoCeram® Cartridge Capacity
Nano Water Filter. You
690 kPa (100 psi)
207 kPa (30 psi)
38°C (100°F)
4°C (40°F)
5.7 LPM (1.5 GPM)
1 year or 11,355 L (3,000 GAL)
23
23

Capítulos

loading