Idiomas disponibles
Idiomas disponibles
Right or left side
Main Breaker Service
Entrance with Bonding
Screw
Uninsulated neutral or ground
See rating label wiring diagram for additional neutral and
ground lug kits
Insulated
Ground or
Neutral
Both Sides
Crossbar
9. Wire branch circuits
Individually wire each branch circuit into a circuit
breaker, then firmly plug each breaker into the interior.
Refer to label on circuit breaker for proper tightening
torque. Use only General Electric circuit breakers specified
on the load center rating label.
breakers or components will void the load center warranty,
may void the UL listing, and can result in property loss or
personal injury.
g
GE Consumer & Industrial
General Electric Company
41 Woodford Ave, Plainville, CT 06062
DEH-40537 R03 03/06 © 2002 General Electric
Visit us on the web at www.GEindustrial.com
Main Lug Only without
Bonding Screw
Insulated neutral or ground
Neutral
Terminal
"A"
Equipment
Ground
Bonding
Screw
Hole Both
Use of other circuit
10. Remove cover KO's
Remove only enough knockout's to match the number of
circuit breakers installed. Close all unused open KO
spaces with Knockout Filler Plates (see catalog numbers
below)
Knockout Width ½"
Catalog Number: TFH
Knockout Width 1"
Catalog Number: TQLFP1
11. Important
Re-tighten all electrical connections before energizing
12. Screw front on box
Adjustment for flush mount will be automatic when cover
is installed
13. Identify circuits
For user's convenience.
NOTE: Accessories and replacement parts are listed on
the label inside the load center door.
These instructions do not purport to cover all details
or variations in equipment not to provide for every
possible contingency to be met in connection with
installation operation or maintenance. Should further
information be desired or should particular problems
arise which are not covered sufficiently for the
purchaser's purpose, the matter should be referred to
the GE Company.
Place
screwdriver
here and tap
with hammer
