Anatomy Of The Dovetailer Ii Jig; Dovetail Router Bit And Bearings - General Tools & Instruments DOVETAILER II Manual Del Usuario

ANATOMY OF THE DOVETAILER II JIG

– Jig Assembly
– Depth Plate
– Template Position Rules
2A
Depth Adjuster Plate
3A
– Depth Measuring Working Surface
3B
– Edge Alignment Teeth
FIG.4
DOVETAIL JIG ASSEMBLY
NOTE: Your jig comes fully assembled for use. The addition of the router control knobs aids in the
use of this jig on router tables.
1. For use on a router table, securely screw in the two Router Table Guide Knobs [6] into the holes
provided on the ends of the jig. Always use the Router Table Guide Knobs when using the jig on
a router table.(FIG. 4)

DOVETAIL ROUTER BIT AND BEARINGS

Included bearings are 1/2 in. outside diameter (OD) and 1/4 in. inner diameter (ID). Router sleeves
or bushings can be used in place of the guide bearings as long as they are also 1/2 in. O.D.
Included router bit is 14˚ x 1/2 in. Other bits can be substituted provided they have a 1/4 in.
diameter shank and have no greater diameter than 17/32 in.
Caution: Keep fingers on control knobs only when using the jig on a router table.
– Template Lock Screws
– Router Table Guide Knobs (2)
– Face Clamp
– Face Clamp Thumb Screws (4)
5