Technical Characteristics - Master KUADRO Manual De Uso Y Manitenimiento

Dear Customer, thank you for purchasing a MASTER S.p.A. product. This guide
contains all the information you will need concerning the use of this product. Read
the instructions carefully and keep them for further consultation. The KUADRO
transmitter is designed specifically to control sun awnings, blinds, roller shutters,
screens or similar items. All other use beyond the field defined by MASTER is
forbidden. This, as well as the breach of the instructions given in this guide, shall
release MASTER from any liability and shall annul the product warranty.
Water, humidity, heat sources and accidental knocks may damage the device. Do
not use abrasive products or solvents to clean the product.
Notes on the radio systems
Do not use radio systems in places with strong interference (for example, near
police stations, airports, banks, hospitals).
It is in any case advisable to carry out a technical inspection prior to installing any
radio system in order to identify possible sources of interference.
Radio systems can be used where any disturbances or malfunction of the
transmitter or receiver do not constitute a risk factor, or if such factor is eliminated
using appropriate safety systems.
The presence of radio devices working at the same transmission frequency
(433.42 MHz) may interfere with the radio receiver and reduce the range of the
system, limiting functionality.
Disposal
At the end of the product life cycle, dispose of the device in
compliance with local regulations. This product could contain
substances that are harmful to human health and the
environment: do not dispose of the product in domestic waste.
Package contents
1 transmitter
1 CR2032 battery
1 support
2 plugs
1 instruction sheet

Technical characteristics

Power: No. 1 CR2032 battery (3 Volts)
Size: 80 x 80 x 13 mm
Weight: 70 g
Operating temperature: 0° / +55°C
Operating frequency: 433.42 Mhz
Operating frequency band: 433,050 – 434,790 Mhz
Max radiated power, e.r.p. : <10 mW
Radio channels: 1
All rights reserved. All products and technical specifications given in this document
are subject to variation without notice. Unless previously and specifically
authorised by the manufacturer, the device must be used exclusively with receivers
produced by the same manufacturer. The manufacturer shall not be liable for
damage resulting from improper, incorrect or unreasonable use.
Basic functions
FUNCTIONS ASSOCIATED WITH THE TRANSMITTER BUTTONS
Tilting
Favorite position
To memorise
rev01.1_22.07.17
Press STOP 6 times quickly then keep
DOWN pressed until the signal of the
Sun/Automatic lowering function
Holding down STOP, press
UP until the LEDs state
changes (approx. 2 seconds).
In this way the function is
changed from active to
inactive and vice versa.
Programming functions
Entering / deleting transmitters
NOTE: Some receivers may not associate some operations to some transmitter buttons or
associate different operations to those described to the transmitter buttons. In this case,
please refer to the receiver instruction manual.
Battery insertion/replacement
The transmitter is powered by a CR2032 battery. To replace the battery, remove the
transmitter from the wall bracket, replace the battery with a new battery of the same type
according to the polarity and place the transmitter in his support.
Using other types of batteries could lead to a risk of explosion. Used batteries must be
disposed of in special containers. As the battery become used, the range of the transmitter
drops gradually until it is completely unusable. Replace the battery at least once every 2
years.
UP
STOP
DOWN
2 x
Or
Press STOP twice quickly and hold down UP or DOWN
6 x
motor (approx. 5 seconds)
Fixing the wall bracket
+
PROG
2 x
To recall
3 x
Press STOP 3 times quickly
(LEDs buttons flash 3 times)
To view the state of the function
hold down a button:
if the LEDs flash, the function is
DISABLE
if the LEDs light up making a
round trick of light, the function
is ACTIVE