Operations:
•
Start UNIKS D3: to press
automatically turn off after about 15 seconds.
• Enable laser / measurement:
press the key to enter continuous measurement mode. The display icon "
measured reflected signal and the number of segments displayed decreases, indicating the relative weakness of the measured
reflected signal
• Benchmark switch: long press the key
reboot.
•
Shutdown: when UNIKS D3 is on, press the button
automatically after 45 seconds.
•
UNIKS D3 setup: long press the key
be corrected in the range of +/- 7mm; It can be set in metric or imperial units; Can set the backlight and beep. Press the
button
for about 1 second while setting the time to change the settings, then briefly press the button
set value
• Area measurement: Briefly press the button
mode, at this moment the long sides of the rectangle icon flash, after locking the measurement point, press the button on the
long measurement of the first side, then on the second side of the blinking rectangle icon, lock points once again, press the
button on the second side length measurement, the tool will automatically calculate the area, the calculation result is displayed
in the main display area, the measurement results lengths of the first and second sides show that in the auxiliary display area.
• Volume measurement: Briefly press the button
measurement mode has been entered and that the volume measurement is completed according to the operation similar to the
area measurement.
• Pythagorean measure: The tool presets three ways to measure the length of the right side of a triangle using Pythagoras' theorem,
including "
screen and complete the measurement of the corresponding function according to the measurement operation of the similar
area.
Note: in the Pythagorean theorem measurement mode, the right angle side must be less than the length of the hypotenuse, otherwise the
instrument will display the error message "DE".
in the off state for about 0.5 seconds to start the meter, when no button is pressed the backlight will
when UNIKS D3 is turned on,
for about 5 seconds to enter the setting state in the off state and the measured value can
"" "is"
". Briefly press the button
press the button
for about 2 seconds to change benchmarks and restore the default benchmark after
for about 1 second to turn it off. When no button is pressed, it turns off
, the display will show the "
until the icon "
until the icon of the corresponding function appears on the display
to turn on the laser or measure the distance, long
"on the screen indicates the intensity of the
, "prompts you to enter the area measurement
"appears on the screen, indicating that the volume
to adjust the