Add Engine Oil And Fuel - Snapper 3000 PSI Instrucciones De Uso

2. Insert carriage bolt through holes from outside of unit
and attach plastic knobs from inside of unit.Tighten by
hand (Figure 2).
i
3. Place accessory tray over holes on handle (viewing
from front of unit). Push the tree clips into the holes
until they sit flat against the accessory tray (Figure 3).
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
CAUTION
* Refer to engine operator's manual for oil and fuel fill
information.
* Damage to equipment resulting from failure to follow this
instruction will void warranty.
• Refer to engine operator's manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oil often during engine break-in. Refer to
engine operator's manual for recommendations.