Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Assembly and Instructions for Use
1. Unpack the product. Wipe off dust with a damp cloth.
2. Familiarize yourself with the pump. The pump speed is controlled by the switch
located at the front of the pump. The speed is indicated by a plus (+) and minus
(-) sign. To increase the speed, move the switch slowly to the left in the direction of
the plus sign. You will hear a click as the switch moves to each speed level. At its
highest speed level, the switch will cease to move any further. To decrease the pump
speed, move the switch to the right toward the minus sign. Similarly, at its lowest
speed, the switch will cease to move any further. (Fig. 1)
NOTE: It is recommended the pump be set at its highest speed during assembly
and later adjusted to a lower setting if desired. Be sure to unplug the
pump before adjusting the speed setting.
Attention:
Figure 1
In order to get
best results,
please operate
pump completely
submerged.
Keep the water
level above the
minimum water
level ALL THE
TIME.
3. Insert the waterproof light into the light clip located inside the base (Fig. 2) so
that lights are facing upwards.
4. Insert the black tube attached to the fountain top into the round opening of the
pump. (Fig. 3)
5. Fill the base with 20 oz. of clean water. Water level should not rise above support
posts. NOTE: We recommend distilled water to prevent mineral build-up.(Fig.4)
6. Place fountain top onto base so that it sits flat. Run the pump power cord out
through the cord slot at the back of the fountain. (Fig. 4)
7. Next attach the four Leaf Cups by inserting the tab, located at the back of each
Leaf Cup, into its corresponding notch on the fountain top. Leaf Cups should
attach to fountain securely. (Fig. 5)
8. Arrange Glass Stones provided on fountain top platform as desired. (Fig. 6)
Figure 2
Base
Light Clip
Waterproof Light
Minimum Water Level
Flow Control Lever
(+) faster water output
(-) slower water output
Figure 3
Black
Top
Tube
Pump
4
9. Attach the Adaptor to the power cord. (Fig. 6)
10. Plug the cord into 120V household outlet. The fountain is controlled by a
switch located on the power cord. If pump does not operate, rotate in-line
switch once to turn "on" and once to turn "off".
Note: Ensure that the electrical cord loops below the electrical outlet to
form a "Drip Loop". This will prevent water from running down the
electrical cord into the electrical outlet. (Fig. 7)
Figure 4
Top
Cord Slot
Pump
Water
Support
Posts
Base
Figure 5
2nd Leaf Notch
2nd Leaf Cup
Bottom Leaf
Notch
Bottom
Leaf Cup
Base
Figure 6
Top
Switch
Platform
Glass Stones
Base
Top Leaf Notch
Top Leaf Cup
3rd Leaf Notch
3rd Leaf Cup
Tab
Leaf Cup
5
Adaptor
Tabla de contenido
