LC-POWER LC-M27-FHD-240-C Manual De Instrucciones página 18

4. Take out the sha� assembly and bracket, and lock them �ghtly with 2
PM5x11mm screws, as shown in the figure below, and then lock the
base and bracket with hand screws.
Sha� assembly
5. As show in the following pictures, put the finished components in step 4
in to the corresponding sinking groove of the rear case. gently press the
bracket to make the sha� assembly snap into the lock, and then hold the
middle posi�on of the bracket to li� the body twice. The buckle can be
used to ensure that the buckle can lock the base assembly;
When disassembling, follow the opposite steps, Make sure the monitor is
laid on a flat surface before removing the stand.
6. Hold the bracket with both hands to place a flat desktop and use the
machine by plugging in the cable.
Note: During the process of erec�ng the machine, do not hold the screen
directly with your hand to prevent breakage; The li�ing range is 100mm,
and the an�-sliding effect should be taken into considera�on when extrac�ng.
Screw
Screw
Hand screw
Eng-5