Cancelling The Programme; Start/Pause Button - Candy CS4 1061DE/1-S Manual De Instrucciones

Opening the door
A special safety device prevents the
door from being opened immediately
after the end of the cycle.
Wait for 2 minutes after the wash
cycle has finished and the "Door
Security" light has gone out before
opening the door.
PROGRAMME selector with OFF
position
When you select a programme the
indicator lights related to temperature
and spin of that cycle will light up.
N.B.: To switch the machine off, turn the
programme selector
position.
l
Press the START/PAUSE button to start
the selected cycle.
l
Once a programme
programme selector remains stationary on
the selected programme till cycle ends.
l
Switch off the washing machine by
turning the selector to OFF.
The programme selector must be
returned to the OFF position at the end
of each cycle or when starting a
subsequent wash cycle prior to the next
programme being selected and started.

START/PAUSE button

Close the door BEFORE selecting the
button START/PAUSE.
l
Press to start
(according to the selected cycle one of
the wash stage indicator lights will
illuminate).
to the OFF
is selected the
the selected cycle
When the START/PAUSE button has
been pressed, the appliance can take
few seconds before it starts working.
PAUSING THE MACHINE
l
Keep the START/PAUSE button pressed
for about 2 seconds (some light indicators
and the residual time display will flash,
showing that the machine is paused).
For safety reasons, in some wash
cycle phases, the door can be opened
only if the level of the water is below
its lower edge and if the temperature
is less than 45°C. If these conditions
are met, wait for the DOOR LOCKED
light to switch off before opening the
door.
l
Press the START/PAUSE button again to
re-start the programme from the point it
had been paused at.

CANCELLING THE PROGRAMME

l
To cancel the programme, set the
selector to the OFF position.
DELAY START button
l
Appliance start time can be set with this
button, delaying the start by 3, 6 or 9
hours.
l
Proceed as follows to set a delayed start:
- Select a programme.
- Wait until the indicator lights related to
temperature and spin of the programme
selected light up.
- Press the delay start button (each time
the button is pressed the start will be
delayed by 3, 6 or 9 hours respectively
and the corresponding time indicator
light will blink).
63