KNOWING YOUr ANGLE GrINDEr
3
5
UNPACKING AND CONTENTS
IMPOrTANT:
Due to modern mass production techniques, it is unlikely the tool
is faulty or that a part is missing. If you find anything wrong, do not operate the tool
until the parts have been replaced or the fault has been rectified. Failure to do so could
result in serious personal injury.
CONTENTS IN PACKAGE
Description
Angle Grinder
Wrench
ASSEMBLY AND ADJUSTMENTS
WArNING:
before adjusting, adding accessories, or checking a function on the tool.
INSTALLING THE AUXILIARY HANDLE
Your grinder is equipped with a two position auxiliary handle. It can be mounted on either the left or right side
of the die cast gear housing. Generally, a right handed operator will grip the body of the grinder with their right
hand and grip auxiliary handle, mounted to the left side of the gear housing, with their left hand. The opposite
gripping and auxiliary handle placement is generally used by a left handed operator. Occasionally, auxiliary
handle placement needs to be changed to accommodate the requirements or restrictions of the operation being
performed.
To Mount the Auxiliary Handle to the Grinder,
the left or right side of the die cast gear housing.
INSTALLING OR REMOVING WHEEL GUARD
To Mount the Wheel Guard
1. Loosen the clamp screw on wheel guard's band by using a #2 Phillips screwdriver,
2. Align the small protrusion on the inside of the wheel guard band with the notch on the grinder's bearing cap
shoulder, then slip the guard's band onto the shoulder of the bearing cap.
3. Tighten the clamp screw securely.
To Remove the Wheel Guard,
4-1/2" Angle Grinder
Operator's Manual
2
4
Q'ty
Description
1
Auxiliary Handle
1
Operator's Manual
Always be sure that the tool is switched off and unplugged
follow the installation procedure in reverse.
1.
2.
3.
1
4.
5.
simply securely screw the handle into the threaded hole on
GAG445SE
On/Off Switch
Auxiliary Handle
Spindle Lock
Wheel Guard
Grinding Wheel
FIG 1
Q'ty
1
1