Casals VNC50 Manual De Uso página 6

Cutting of mitre angles (Fig 3):
- Loosen the set off screws (H) using the
Allen wrench (I)
- Tilt the shoe (D) to the required miter
angle. (0-45º left or right).
- Tighten the set of screws (H) firmly.
Front flush cuts (Fig 4):
- Loosen the set off screws (H) using the
Allen wrench (I)
- Slide the shoe (D) all the way back.
- Tighten the set of screws (H) firmly.
Curved cuts:
For sawing on a curve, use the special
"curved cut" blade, which is thin enough to
saw along a curve.
Perforating wood (Fig 5):
To perforate wood, there are two
possibilities:
1- Drill a hole and begin sawing from that
point.
2- Use the following technique (see fig. 5):
- Place the jig-saw on the rounded edge
located at the front of the bottom plate.
- Turn on the saw and slowly lower it until it
touches the material to be sawed.
- Once the material has been perorated,
return the saw to its normal position and
continue sawing.
Once you have finished using the
appliance:
- Stop the appliance by releasing the on/
off switch .
Cleaning
- Disconnect the appliance from the mains
and allow it to cool before undertaking any
cleaning task.
- Clean the electrical equipment and the
mains connection with a damp cloth and
dry. DO NOT IMMERSE IN WATER OR ANY
OTHER LIQUID.
- Clean the equipment with a damp cloth
with a few drops of washing-up liquid and
then dry.
- Do not use solvents, or products with an
acid or base pH such as bleach, or abrasive
products, for cleaning the appliance.
- Do not let water or any other liquid get
into the air vents to avoid damage to the
inner parts of the appliance.
- Never submerge the appliance in water or
any other liquid or place it under running
water.
- If the appliance is not in good condition
of cleanliness, its surface may degrade
and inexorably affect the duration of the
appliance's useful life and could become
unsafe to use.
Supplies
- Always use original supplies, designed
specifically for your appliance model.
- These supplies are available in specialist
shops.
Anomalies and repair
- Take the appliance to an authorised
technical support service if a product
damage or other problems arise. Do not try
to dismantle or repair without assistance,
as this may be dangerous.
- If the connection to the mains has been
damaged, it must be replaced and you
should proceed as you would in the case
of damage.