Vava VA-VD002 Manual Del Usuario página 6

Dash Cam Installation
1
2
1. Turn off the car engine.
2. Stick the car mount onto your car windshield (ideally right in the middle).
3. Fix the VAVA Dash Cam onto the mount via the magnet.
4. Connect the USB cable to the micro USB port of the dash cam. Run the cable along the edge of the
windshield, tuck it away in the seams, and extend it all the way to the USB port of the Car Charger.
Be sure to keep it away from the airbag area.
5. Insert the Car Charger into your cigarette lighter, connect the Dash Cam to the Car Charger.
6. Plug the rear camera connecting cable into the rear camera connecting port, and install the rear
camera properly.
A
B
7. Adjust the dash cam to keep the lens level with the ground.
8. Start the car engine to check if the dash cam is working properly.
Snapshot Button
Dash Cam and Snapshot Button Pairing
Dash Cam and Snapshot Button Pairing: Once the dash cam is turned on, press and hold the Snapshot
Button for 5 -20 seconds until you hear 4 beep sounds and they are synced.
Installing the Snapshot Button
① Install the Snapshot Button onto the steering wheel with the 3M sticker.
② Install it on the key ring or no installation is applied (Pay attention not to miss it).
Using the Snapshot Button
① Taking photos: Press once to take photos
② Taking short videos: Press and hold for 3 seconds with a beep sound to take videos.
Replacing the battery:
Batterry Model：Lithuim Battery CR 2032 3V
Replace the battery: Open the Bluetooth Button and put the battery inside with the right polarities.
Notes：The Snapshot Button enters standby mode once there is no operation in 1 minute.
Press again to restart and take a photo.
05/06