Idiomas disponibles
Idiomas disponibles
CSA 20L 115
Cutting-off
WARNING! Always use the closed guard for cutting-off operation for metal.
• While cutting-off, do not press the tool, do not twist, do not turn.
• Enter with grinding wheel at a 90 ° angle in the workpiece.
• Work with moderate, the material to be machined custom feed.
• Do not stop the wheel with lateral pressure
• Expiring not brake discs with side pressure.
• The direction in which the abrasive cutting is performed is important.
• The machine must always opposite to the rotational direction of the cutting wheel to be moved.
Therefore, never move the machine in the other direction! There is a danger that it could be
pushed out of the uncontrolled intersection.
Cleaning and Maintenance
Warning! Switch of and disconnect from power supply before carrying out cleaning and
maintenance work.
1. Remove dust and dirt with a cloth slightly dampened with detergent solution. In doing so, ensure
that no water gets into the tool.
2. Do not use aggressive and abrasive detergents, they might damage the housing.
3. Regularly clean drillings and dust out of the chuck and the ventilation slots.
4. The appliance is permanently lubricated and does not require oiling.
Repair
Do not try to repair this tool on your own. Always hand the tool to a qualified technician.
Disposal
Information on disposal for users of waste electrical & electronic equipment.
This symbol on the products and/or accompanying documents means that used
electrical and electronic products should not be mixed with general household waste.
For proper treatment, recovery and recycling, please take these products to
designated collection points, where they will be accepted on a free of charge basis.
Disposing of these products correctly will help to save valuable resources and prevent
any potential negative effects on human health and the environment which could
otherwise arise from inappropriate waste handling. Please contact your local authority
for further details of your nearest designated collection point.
16
