Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
Installation
1
Turn off power to the electrical outlet.
2
Move the unit near the opening. Remove and recycle
packing materials.
3
30" models are shipped with two shipping brackets
located on each side behind the front face. Remove
both brackets, then reinstall the screws. Refer to the
illustration below.
Plug the power cord into the grounded outlet.
4
5
Position the microwave oven in the opening and slide
back until the mounting flange is flush with the face of
the cabinet. Avoid pinching the power cord between
the unit and cabinet wall.
Open the door. Using the two holes on either side of
6
the mounting flange as a template, drill pilot holes into
the cabinet using a 1/16" drill bit.
Mount the microwave oven using the four screws pro-
7
vided. Refer to the illustration below.
Turn power back on to the electrical outlet.
8
REMOVE
BRACKETS
THEN REINSTALL
SCREWS
Shipping brackets
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf &
Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
MOUNTING
SCREWS
Mounting screws
Troubleshooting
IMPORTANT NOTE: If the microwave oven does not
operate properly, follow these troubleshooting steps:
•
Verify electrical power is supplied to the microwave
oven.
•
Verify proper electrical connections.
•
If the microwave oven does not operate properly,
contact Wolf Factory Certified Service. Do not attempt
to repair the oven. Wolf is not responsible for service
required to correct a faulty installation.
wolfappliance.com | 7
Tabla de contenido
