Charging Indicator; Charging Procedure - Lista ASB-20 Manual De Instrucciones

Aspiradora/ soplador a bateria
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

D2
3. CHARGING YOUR BATTERY PACK
(ACG18LD3/ACG1830D) (SEE FIG. E1, E2)
Do not use any charger other than that
specifically provided for use with the equipment.
If the battery pack is very hot you must remove
your battery pack from the charger and allow
time for the battery to cool down before
recharging.
Please charge the battery to reach full before
storage. If the tool will not be used for long
periods of time, charge the battery every 3
months.
E1
green
light
E2

CHARGING PROCEDURE

1) Plug the charger into an appropriate outlet.
The light will be green.
2) Slide the battery pack into the charger, make
sure the battery is in the correct charge
position firmly. The light will turn to red to
indicate the charging process has started.
3) When charging is completed, the light will turn
to green.
red
light
4) After fully charged, unplug the charger and
remove the battery pack.
NOTE: If the battery pack is locked in the
charger, press the battery pack release button
and remove it.
WARNING: When battery charge runs
out after continuous use or exposure
to direct sunlight or heat, allow time for the
battery to cool down before re-charging to
achieve the full charge.

CHARGING INDICATOR

This charger is designed to detect some
problems that can arise with battery packs.
Indicator lights indicate problems (see table
below). If this occurs, insert a new battery pack
to determine if the charger is OK. If the new
battery charges correctly, then the original pack
is defective and should be returned to a service
center or recycling service center.
If the new battery pack displays the same
problem as the original Battery Pack, have the
charger tested at an authorized service center.
Light
ON/OFF
flash
Red on
Red flash
- - - -
Green on
Green flash
- - - -
NOTE: The battery chargers and the battery packs
illustrated or described above are not included in
the delivery.
4. ADJUSTING AUXILIARY HANDLE (SEE FIG.
F)
Press the auxiliary handle locking knob. Rotate
the auxiliary handle to the most comfortable and
balanced position. Then release the auxiliary
handle locking knob.
Status
Charging
Defective Bat-
tery
Fully Charged
Hot/Cold Delay
41
Tabla de contenido
loading

Productos relacionados para Lista ASB-20

Tabla de contenido