Installation To Double Wood Stud Wall - PEERLESS Mounts EWMU Instalación Y Ensamblaje

Installation to Double Wood Stud Wall

• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that wall plate is fi rmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud fi nder
is highly recommended.
• When installing Peerless wall mounts on a wood stud wall covered with gypsum board (drywall), verify that the
wood studs are a minimum of 2" x 4" nominal size. Do not install over gypsum board thicker than 5/8".
Use a stud fi nder to locate the edges of the studs. Use of an edge-to-edge stud fi nder is highly recommended.
1
Based on their edges, draw a vertical line down each stud's center. Place wall plate (A) on wall as a template.
The top mounting slots should be located 4.0" (102 mm) above the desired screen center as shown in fi gure 1.1.
Level plate, and mark the center of the four mounting holes. Make sure that the mounting holes are on the stud
centerlines. Drill four 5/32" (4 mm) dia. holes 2.5" (64 mm) deep. Make sure that the wall plate is level, secure it
using four #14 x 2.5" wood screws (D) and four fender washers (M) as shown in fi gure 1.2.
Skip to step 2.
CS
STUD
CS = center of screen
16" - 24"
41cm - 61cm
4.0"
(102 mm)
A
fi g. 1.1
WARNING
D
M
4 of 32 ISSUED: 06-22-10
A
SHEET #: 061-9052-12
fi g. 1.2
(2017-11-02)