Advanced Operation - Xtech MALLOY XTS-621 Guía De Instalación Rápida

V. Advanced operation
Note: Before using this product, please make sure it has the built-in
Bluetooth feature available.
®
Pairing the speaker with your phone
1. Make sure the speaker is off.
2. Set your Bluetooth phone to "discover" the wireless speaker.
®
3. Place both devices not more than one meter away from each other.
4. Turn ON the speaker by pressing and holding the Power button. The blue
LED starts blinking, accompanied by a short tone, to indicate that the
device has entered into the pairing mode and is ready to be detectable for
the first time.
5. On your mobile phone, tap the newly discovered audio device (XTS-621)
displayed in the Bluetooth list.
®
6. When the speaker asks if you want to pair with it, click Yes or OK to accept.
7. If you have a lower Bluetooth
®
passkey 0000 (4 zeros).
8. If pairing is successful, a tone will be heard and the LED will turn solid blue.
If after 60 seconds the pairing process fails, please repeat steps 1 through 7
described above.
9. We recommend turning off the device when not in use, to conserve battery
power.
version, you may be prompted to enter the
Using the speaker to answer and end a call
• When there is an incoming call, the speaker will generate a tone to alert you
of this event.
• Briefly press the Power/Handset button to pick up. You may also press the
answer button on your cellular phone to take the call using the speaker.
• To end a call, press the Power/Handset button once again. Likewise, you
may also end the call directly using the command on your cell phone.
• When listening to music using your mobile phone, playback will resume
automatically once the call has ended.
• By pressing the Power/Handset button twice, the phone will redial the last
number called (on supported devices).
• Press and hold the Power/Handset button for about 2 second to send a call
to voice mail.
VI. Auxiliary mode operation
a. First, connect one side of the supplied 3.5mm cable to the auxiliary port on
the speaker and the other side of the cable to the source of choice.
b. Turn on the speaker as it was previously instructed, and adjust the volume
to your desired level.
c. Press the Mode button to switch to the Auxiliary-in mode.
d. Start streaming audio files directly from the source of choice.
e. The speaker will remain in this mode until the Mode button is pressed to
change to the mode of choice or until the 3.5mm cable is disconnected.
Once disconnected, the speaker will switch to BT mode.