ARDES AR1F62I Instrucciones De Uso página 8

If the "SELECT" button is pressed again, the TEMP light will come on: the display
will show a preset value of 180°C; you can now set the desired temperature by using
the +/- buttons, from a minimum of 60°C to a maximum of 240°C with intermediate
values in increments of 20°C
The high quality ceramic hob is easy to clean. Stains caused by food or water spills
must be removed so that they do not cause a bad odor.Disconnect the plug from the
socket and let the appliance cool down well before cleaning it.
In order to clean the appliance, use a soft or slight damp cloth.
Never use abrasives or chemical solvents.
NEVER IMMERSE THE APPLIANCE INTO THE WATER.
It is recommended to check periodically that the cable does not have cuts or
burnings due to the nearnes of the plate.
E01 – IGBT open or short-circuited.
Call an authorized service centre.
E02 – Overheating (>180°C)
for example if an empty pan is left on the hot device, the latter will overheat
signalling the error.
Eliminate the cause of overheating by removing the pan, paying attention because
it could be very hot, or switch off the device and let the pan cool down.
Once the hob has cooled, the device can be restarted.
If the fault persists, call an authorized service centre.
E03 – The supply voltage is too low or too high .
Check that the device is connected to the supply voltage indicated on the label
plate data.
If the fault persists, call an authorized service centre.
8
MAINTENANcE
TROUbLEShOOTING