Product Description; Technical Data; Components; Factory Setting On Delivery - Steelcase Solo Sit-to-Stand Desk Instrucciones De Uso

_______________________________________________________________
3

Product description

Dimensions and weight specifications of your product
can be found on the delivery note.

3.1 Technical data

Dimensions and weight
Temperature range at the
setup location
Relative humidity
Input voltage range
Frequency range
Maximum load capacity
Maximum "ON" duration
Input current
Maximum adjustment range:
Double telescope (Lift 2)
Noise emission
Max. power consumption
during lifting
Power consumption in
standby mode
Memory control panel
Type plates are located on the power lift housing, on
the columns, and under the desktop near the control
panel.
Type plate: symbols – explanation
Double insulation. Double insulated
cables minimise the risk of electrical
shock.
For indoor use. Indicates that
placing the product outdoors is not
allowed.
CE marking. Used to symbolise the
conformity of the product with the
applicable requirements that the
European Community places on the
manufacturer.
157238
Solo Sit-to-Stand Desk
See delivery note
+5°C to +35°C
5% to 80% (non-condensing)
220 to 240 V ˜
50 to 60 Hz
75 kg
2 min. ON/18 min. OFF
2.5 A
650 mm to 1250 mm
<60 dB (A)
240 W
≤ 0.2 W
Standard
Recycling symbol. Used to indicate
conformity with the regulations for
Waste Electric and Electronic
Equipment (WEEE) and the Electrical
and Electronic Equipment Act
(ElektroG). Electrical and electronic
products must be disposed of
separately from household waste at
the end of their service life.
The CE marking is located on the underside of the
desktop and can be viewed at any time.

3.2 Components

The Solo Sit-to-Stand Desk essentially consists of
the following components (the variant descriptions
can be found in the respective chapters):
Desktop
■
Horizontal structural profile section (bolted to the
■
desktop)
Software and hardware-supported stopping
■
device with a sensor for system protection
Columns with bolted steel pipe runner (88.5 x 48
■
x 1.5 mm), including adjustment screw for
compensating floor unevenness, and a cable duct
Plastic cap, top left/right
■
Desktop support, top left/right
■
Electrical height adjustment:
■
Lift 2: Electric motor (650 to 1250 mm), in
–
column, including software-supported
stopping device and sensor
Power lift for lifting height adjustment
–
Standard: Memory control panel with display
–
for height indication; programming function
for four desk heights

3.3 Factory setting on delivery

Lift 2 variant: 690 mm
■
You can change these settings according
to your needs. The corresponding
descriptions can be found under
Operating and adjusting
Product description
5
.
5