Satco NUVO 65-131 Instrucciones De Instalación Y Seguridad

LED SMALL WALL PACK
Models: 65-131, 65-132, 65-133
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixuture. Retain for future reference.
WARNING:
• To reduce the risk of personal injury or property damage from fire,
electric shock, falling parts, cuts/abrasions, and other hazards read
all warnings and instructions included with and on the fixture and all
fixture labels.
• Commercial installation, service and maintenance of luminaries should
be performed by a qualified licensed electrician. For The installation:
If you are unsure about the installation or maintenance of the
luminaries, consult a qualified licensed electrician and check your
local electrical code.
• Turn off electrical power at fuse or circuit breaker before wiring fixture
to the power supply.
• Turn off the power when you perform any maintenance.
• All connections should be capped with UL approved wire connectors.
• Minimum size 18 AWG or 14 AWG for continuous runs.
• Risk of Burn. Disconnect power and allow fixture to cool
before handling.
• Verify that supply voltage is correct by comparing it with the
luminaire label information.
• Do not install in a hazardous atmosphere, except where the ambient
temperature does not exceed the rated operating temperature of
the fixture.
• Keep tightly closed when in operation.
INSTALLATION:
1. Before starting ensure that the power is disconnected.
2. Unpack fixture and ensure that there are no damaged parts.
3. Remove the quickmount mounting plate from the back
of the fixture.
4. Direct Mounting to Junction Box:
• Fasten mounting plate to recessed outlet or other
mounting surface. Use the integral bubble leveler to
ensure that the plate is level.
• Splice the power leads from the back of the fixture to the
branch circuit leads from the junction box. Connect the
wires as seen in wiring diagram.
5. Wall-mounted wiring box with conduit feed:
• Attach the wiring box to the desired location using the
bolt holes provided.
• Remove the threaded plug(s) and route electrical conduit
to the holes desired. Feed the branch circuit wires through
the conduit into the wiring box.
• Splice the fixture power leads to the power leads inside
the wiring compartment and wire as seen in wiring
diagram.
6. Align the fixture against the wiring box and tighten the set
screws to secure the fixture in place. Take care not to pinch
the power wires.
© Copyright 2017 Satco Products, Inc. 4/17
ELECTRICAL REQUIREMENTS:
• The LED driver must be suplied with 120 or 277V, 50/60 Hz
and connected to an individual, properly grounded branch circuit
protected by a 20 ampere circuit breaker. Use min. 75°C supply.
GROUNDING INSTRUCTIONS:
• The grounding and bonding of the overall system shall be
done in accordance with NEC Article 600 and local codes.
TOOLS REQUIRED:
• 1/8" Allen Hex Key
• Wire Strippers
• Wire Cutters
Cut-off Wallpack
Wiring Diagram
Satco Products, Inc.
Brentwood, NY 11717