Presto H-DRY Q7207-0 Guia De Instalacion página 14

Cleaning
Periodic cleaning of the unit is recommended to ensure optimal performance.
Disconnect the electrical supply.
Remove the two cover-mounting screws.
Remove the cover from the dryer body.
Clean the inside of the dryer and remove any dust or lint.
Do not flush with water.
Wipe the cover with a damp cloth and mild cleaning solution. Do not Soak. Never use abrasives to clean the cover.
Replace the cover. Do not over tighten the screws.
Warm Air Speed Adjustment
Switch off the power, remove the cover screws and the cover
Use a small Philips head screwdriver or a plastic flat blade
probe to turn the VR shaft. Clockwise to increase power to
maximum (+), Clockwise to reduce power as needed (-)
VR.FOR AIR SPEED
Heater Element Switch ON/ OFF
Switch off the power, remove the cover screws and the cover
Adjust the heater switch on the CBM with a small plastic or
wooden flat blade probe
Slide the switch to "ON" : heater on
Slide the switch to "1" : heater off
Switch for heater
Sensor Range Adjustment
VR.FOR SENSOR
The range is 100 to 230, standard setting is 130 mm ± 20
Clockwise : Increases the sensing range(+)
Counterclockwise : Decreases the sensing range(-)
DO NOT OVERTURN!
14