Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3. Connect the wireless controller following the
instructions in the "Powering on the Device"
section in this guide. The boot sequence will
be displayed on the terminal.
4. Once the boot sequence is completed, the
command prompt will be displayed and the
device is ready to be configured.
Discovering and Managing the
Unified AP
Internet
Switch
LAN
Unified
Access
Point
Figure 10. Network Topology
To discover and manage the Unified AP:
1. Record the MAC address of each Unified
AP on the network.
2. Connect the Unified AP you want to configure
to the local area Ethernet network.
3. Log into the DWC-2000 and set the LAN IP
address to be in the subnet of the local area
Ethernet network.
4. Go through the Wizard to manage your
access points. Click "Wizard" at the top right
corner.
Figure 11. Wizard
Router/
DHCP
Server
LAN
DWC-2000
5. Click the "Run..." button to run the WLAN
Wizard.
Figure 12. Run WLAN Wizard
1. Enter
the
following
complete the WLAN Setup Wizard:
•
Wireless Global Configuration: Choose
the country code.
•
Wireless Default Radio Configuration:
Create an AP Profile for the radio setting
of the wireless network. Set the radio
mode for each radio.
•
Wireless Default VAP Configuration:
Enter the SSID network name, and then
select a security method. If you select
Static WEP or WPA Personal, enter a
secure passphrase for your WLAN.
Figure 13. WLAN Wizard
2. Below are two methods to add access
points in the managed AP list:
a. List of APs Awaiting to be Configured:
Select the access points which are
discovered automatically by the wireless
controller.
b. Valid Access Point Summary: Enter
access point MAC address manually.
List of APs Awaiting to be Configured: This
is a list of discovered access points. Switch
the Status of the access point you want to
manage to ON.
information
to
5
Tabla de contenido
