OWNER'S MANUAL FOR:
Shallow Water HP Series
SWHP20 & SWHP40
MAX DEPTH 10'
Important Safety Instructions
• Read all operating instructions carefully.
• To reduce the risk of electric shock, connect only to a properly grounded, grounding-
type receptacle. If in doubt, have the outlet checked by a qualified electrician.
• This unit is to be used in a circuit protected by a ground fault circuit interrupter (GFCI).
• Disconnect unit from power source before handling or maintenance.
• Repair or exchange of cable/power cord must be carried through by the supplier/
manufacturer.
• This unit has not been investigated for use in swimming pool areas.
CAUTION
• Never connect to an extension cord. This may result in equipment failure.
• Do not allow anything to rest on the power cord.
• Do not place the cabinet where people may step on the power cord.
• Never override or "cheat" electrical or mechanical interlock devices.
• Never attempt any maintenance function that is not specified in the user manual.
• Never operate the system if unusual noises or odors are detected. Disconnect the
power cord from the outlet and call for service.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory, or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning the use of the appliance
by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• The appliance is to be supplied through a residual current device (RCD) having a
rated residual operating current not exceeding 30 mA.
GROUNDING INSTRUCTIONS – This product must be grounded. In the event of
an electrical short circuit, grounding reduces the risk of electric shock by providing
an escape wire for the electric current. This product is equipped with a cord having a
grounding wire with an appropriate grounding plug. The plug must be plugged into an
outlet that is properly installed and grounded in accordance with all local codes and
ordinances.
2
THANK YOU FOR CHOOSING
The Airmax
Aeration System
®
Watch & Learn |
Watch & Learn | How-To Install Video
airmaxeco.com/AirmaxAerationInstallation
ENGLISH
SECTION
1
System Components
2
System Installation
3
Initial Start-Up &
Seasonal Operation
4
Maintenance
5
Troubleshooting
6
Replacement Parts / Accessories 10
7
Warranty
WARNING – Improper installation of the grounding plug is able to result in a risk of
electric shock. When repair or replacement of the cord or plug is required, do not
connect the grounding wire to either flat blade terminal. The wire with insulation having
an outer surface that is green with or without yellow stripes is the grounding wire.
Check with a qualified electrician or serviceman when the grounding instructions are
not completely understood, or when in doubt as to whether the product is properly
grounded. Do not modify the plug provided; if it does not fit the outlet, have the proper
outlet installed by a qualified technician.
For 120 VAC products: This product is for use on a nominal 120V circuit, and has a
grounding plug similar to the plug illustrated in sketch A in Figure below. A temporary
adapter similar to the adapter illustrated in sketches B and C may be used to connect
this plug to a 2-pole receptacle as shown in sketch B when a properly grounded outlet
is not available. The temporary adapter shall be used only until a properly grounded
outlet (sketch A) is installed by a qualified electrician. The green colored rigid ear, lug,
or similar part extending from the adapter must be connected to a permanent ground
such as a properly grounded outlet box cover. Whenever the adapter is used, it must
be held in place by a metal screw.
For 230 VAC products: This product is for use on a circuit having a nominal rating
more than 120 V and is factory-equipped with a specific electric cord and plug for
connection to a proper electric circuit. Only connect the product to an outlet having
the same configuration as the plug. Do not use an adapter with this product. When
the product must be reconnected for use on a different type of electric circuit, the
reconnection shall be made by qualified service personnel.
How-To Install Video
See Other Languages Online
PAGE
4
5-8
8
9
9
11