Led Status; Music Playback; Bluetooth ® Indicator - KlipXtreme Oryx KBS-600 Manual Del Usuario

V. Using the speaker to answer or end a call
• When there is an incoming call, the speaker will generate a tone to alert you of this event.
• Briefly press the multifunction key to answer the call on the speaker, you can talk close to
the speaker as the built-in microphone will allow clear voice reproduction. You may also
press the answer button on your phone to take the call using the speaker.
• To end a call, press the multifunction key once again. Likewise, you may also end the call
directly using the command on your cell phone.
Note: When listening to music using your mobile phone, playback will resume
automatically once the call has ended.
• Press the multifunction key for approximately two seconds on the speaker in order to
reject an incoming call.
• Press the multi-function button twice to call back the last number dialed on your phone.
VI. Music playback
Note: Music playback will work individually or in TWS mode.
• Press the multi-function button to start and stop audio playback.
• Press and hold the button to play the next track.
• Press and hold the button to play the previous track.
• In order to adjust the volume level, briefly press the or button.
VII. LED STATUS
Battery charging LED indicator:
• The battery indicator LED's individually flash as it charges.
• The battery indicator LED's lit up solid once it is fully charged.
Bluetooth indicator:
®
• The Bluetooth LED blinks quickly when the devices are pairing.
®
• Once the pairing is successful the Bluetooth
blink slowly when music is being played.
• The device will power off automatically if the speaker has been inactive for more than 10
minutes, as long as the speaker is not connected to Bluetooth
• The Bluetooth LED blinks quickly when the speaker is turned on.
®
• When the speaker is in TWS mode, the Bluetooth
paired in TWS mode.
Power LED Indicator:
• The power LED (red) is lit during charging. After the speaker is fully charged the red LED
will turn off.
• The power LED will blink if the battery level is low.
• The Battery indicator LED's will blink as the unit is charging, the status of the LED's will
become solid as the charging status increases. Once all four LED's become solid, this is an
indication that the speaker is fully charged.
LED indicator will become solid. It will only
®
.
®
LED blinks, then becomes solid once
®