Disassembly Instructions; Important - Gardenline 22098-19 Manual Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Leg Hinge
STEP 3:
With each person holding a frame leg in hand, slide the leg hinge (see
picture) upwards until it locks in place using the pushpins near the top
of the legs. If you are having difficulty moving the leg hinge up, make
sure the frame is fully extended.
STEP 4:
Each leg is telescopic, consisting of an upper section and a lower
section that can be pulled out. Each person should place their foot on
the base of the leg and lift upwards. This allows the lower section of
the leg to be drawn out from the inside of the upper section. Continue
extending the lower section until the locking pins engage the lowest
height setting. All four legs should be locked in place at this height
to prevent the legs from closing back in on themselves. Once at the
lowest height, choose how much higher you would prefer the unit to
be by selecting from the remaining heights (holes) available. Use the
fastening straps found around the canopy to secure it to the bars that
make up the accordion X's; see page 10 for part descriptions.
STEP 5:
Run Stakes (C) through the designated holes found at the base of each
leg. Screw Stakes (C) clockwise while inserting them into the ground for
extra stability.
STEP 6:
Run Guide Ropes (D) through the loops found at the tops of the four corners
of the canopy. Secure the Guide Ropes (D) by tying a knot at each end.
Secure the opposite ends of the Guide Ropes (D) to Stakes (C) by tying knots.
Insert the Stakes (C) into the ground by screwing them in place as noted in
Step 5. When completed, the Guide Ropes (D) should be tightly drawn.
8
MODEL: 22098-19 PRODUCT CODE: 1537
Assembly Instructions
AFTER SALES SUPPORT
1800 599 8898
USA
06/2019
USA
IMPORTANT: Do not use excessive force when closing and putting
the product away. It is advised to have four people to assist with
taking the product down.
1. Untie and remove the ropes and pull the stakes from the ground.
2. Remove the stakes securing the base of the legs to the ground.
3. Push in on the pushpins found on the legs so that the upper section
collapses over the lower section of each leg. Close each leg completely
so that it is in its compact state.
4. Release the leg hinges on each leg by gently depressing the push
buttons and sliding the hinges down slightly.
5. One person should be at each leg and begin walking inwards,
gradually closing the frame at the same pace. If resistance is met, take
a step back before attempting to close the unit again. Do not force the
product closed to avoid damaging parts.
6. When the frame is closed and in its compact state, place the product
in its carrying bag.
KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS CANOPY
FABRIC. This canopy is made with fabric that meets CPAI-84
specifications for flame resistance. It is not fire proof. The fabric
will burn if left in continuous contact with any flame source. The
application of any foreign substance to the canopy fabric may render
the flame-resistant properties ineffective.
AFTER SALES SUPPORT
1800 599 8898
USA
MODEL: 22098-19 PRODUCT CODE: 1537

Disassembly Instructions

WARNING
06/2019
USA
9
Tabla de contenido
loading

Tabla de contenido