SSS Siedle BVM 650-0 Manual Del Usario página 7

Programming –
manual (Mod. 2)
The BVM 650-... with switch posi-
tion 2 is used for connecting an
external camera without door sta-
tion to the Siedle In-Home bus:
Video.
1 Switch on the programming mode.
At the BNG/BVNG 650-..., press the
programming mode button briefly.
The LED 1 flashes in a 2-second
rhythm to indicate that the program-
ming mode is active.
4 Hold down the light button for
4 seconds. A protracted signal tone
is audible in the receiver. The bus tel-
ephone is now in the programming
mode. Do not replace the receiver!
The camera picture can be seen on
the monitor.
External camera dialling can be
programmed as a function on a bus
telephone button.
This function can be programmed
for any bus telephone to any button.
BVM 650-0
Bus-Video-Modulator Bregstraße 1
78120 Furtwangen
Bus video modulator
Germany
Modulateur bus vidéo
IP 20
1 2
Mod. Status Prog. Mod.
2 At the BVM 650-... hold the
programming button down for
4 seconds. After this, the status LED
flashes at short intervals as long as
the programming mode is active.
5 At the bus telephone, hold down
the button you wish to use to call
the external camera for 4 seconds.
Replace the receiver at the bus tel-
ephone. The button is now assigned
to the external camera. The external
camera can be selected at any time.
The only exception is the door
release button.
3 Lift the receiver at the bus tel-
ephone which you wish to program.
6 Replace the receiver. Continue to
program more bus telephones or
quit the programming mode.
7