Emerson insinkerator TranScape View HC-View-SS Instalacion, Cuidado & Uso página 3

COMPONENTS IN THIS PACKAGE
HC-View-SS Extension & Star Nut
Washers
1-5/8" 1-5/8"
HC-Wave-SS
Rubber Small Steel
H-View-SS
Extension & Star Nut
Washers
1-5/8" 1-5/8"
H-Wave-SS
Rubber Small Steel
3/4" Screws (2)
Semi-Circular
H990-SS Mounting Plate
Fiber Gasket Mounting Plate
H770-SS
4
3/8" Tube
Brass Nut / Ferrule /
3/4" Screws (2) Quick Connector
2-1/4" 2-1/4"
Snap-Connect
Large Steel Fiber Fitting (3 pieces)
3/4" Screws (2)
2-1/4" 2-1/4"
Snap-Connect
Large Steel Fiber Fitting (3 pieces)
Snap-Connect
Wing Nut Rubber Gasket Fitting (3 pieces)
3/4" Screws (2)
Metal Snap-Connect
Mounting Screw Fitting (3 pieces)
START HERE
1
PREPARATION
A
Required minimum from
center of hole to wall
HC-View-SS ...... 2
H-View-SS ........ 2
Tube Insert
HC-Wave-SS .... 2
H-Wave-SS ...... 2
H990-SS .......... 1
H770-SS .......... 2" ............................
Tank
The wall outlet for your dispenser must have power supplied to it continuously
and must be fused. It should not be controlled by the same wall switch
that operates your disposer, unless using an InSinkErator SinkTop Switch
B
Tank
If you have to drill through sink or
countertop, you may need to rent or purchase
Tank
C
Consult a professional before drilling into
Tank
a surface other than stainless steel.
PROPER INSTALLATION SHOULD TAKE ABOUT 2-4 HOURS
I I
Identify locations for the dispenser
Maximum counter
faucet, tank and filter (if applicable).
thickness (depth)
I I
Check to make sure there is proper
5 ⁄ " ..........................3"
8
clearance (see chart at left) for
5 ⁄ " ..........................3"
8
dispenser handles to be fully opened.
5 ⁄ " ..........................3"
8
3 ⁄ "..........................3"
I I
8
Check to make sure counter is not
1 ⁄ " ..........................3"
4
too thick (see chart at left).
3 ⁄ "
4
I I
Make sure there is a grounded
electrical outlet under the sink.
I I
Turn off water supply.
I I
If using the sink sprayer hose hole,
remove nut that connects sprayer
hose at bottom of faucet.
I I
Using adjustable wrench, remove nut
connecting sprayer washer flange in
sprayer hole.
I I
Plug hose opening with either a 1/8"
plug or a 1/4" cap (not supplied).
the appropriate tools.
What if you don't have a sprayer hole or
don't want to use it?
I I
Many homeowners replace the soap
Required Hole Size
dispenser in their sink with an instant
1 ⁄ " - 1 ⁄ "
1 1
4 2
hot water dispenser.
Dependent on model
I I
If drilling a hole into a stainless steel
sink or counter top, you can cut a
mounting hole for the dispenser with a
hole saw for stainless steel, or you can
use a hole punch.
TM .
5