TACKLIFE RTD35ACL Manual Del Operador página 6

Operation
Inserting the various tools
• Before inserting a tool (and before each tool change) switch of the drive unit and pull the power plug.
1. Press the locking knob (4) and turn the collet chuck until the bolt locks into place.
2. Undo the collet chuck nut (3).
3. Insert the required tool into the sleeve and tighten the collet chuck nut (3).
Installing the flexible shaft (Fig.3)
• Unscrew the cover (5) from the front of the equipment.
• Undo the collet chuck nut (3).
• Insert the internal schaft (a) of the flexible shaft into the collet chuck (3).•
• Tighten the collet chuck nut (3).
• Now tighten the ring (b) on the multi-tool.
Using the tool for the first time
• Make sure that the drive unit is switched off.
• Check that the mains voltage specified on the rating plate of the power supply unit is the same as
your mains supply. Only then should you insert the plug of the power supply unit into a socket-outlet.
ON/OFF switch (Fig. 1)
Switch on the drive unit with the power switch (1).
Speed selector (Fig. 1)
The required speed can be set with the speed control (2).
The correct speed depends on the tool used and the type of material being processed.
Directions for use
• With small milling cutters / grinding pins: Use a high speed.
• With large milling cutters / grinding pins: Use a low speed.
• Precision work / engraving: Hold the drive unit like a pen.
• Rough work: Hold the drive unit like a hammer.
Tips
• Exert only moderate pressure on the workpiece and allow it to be processed at uniform speed.
• You will not finish your work sooner by exerting heavy pressure. On the contrary, heavy pressure will
cause the drive unit to slow down or stop and will overload the motor.
• For your own safety, use a vise or screw clamp to secure small workpieces.
Removing the rotary tool detachable handle
- 04 -