Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Finishing
WARNING
!
•
Power supply service must be completed prior to finishing to avoid reconstruction.
•
Heat vents and air openings cannot be covered in any circumstances.
1. front glass removal / installation
Unplug the LED back lights (see "LED back lights" section).
A.
B.
With one hand on the front glass to prevent it from falling, remove the two screws (1 per side) from the
top of the appliance (Fig. 4-1). Set the screws aside.
C.
Carefully lift the front glass up and away from the appliance (Fig. 4-2). Place it face down on a soft, non-
abrasive surface.
D.
Reverse these steps to install the front glass.
2 . crystal / pebble media installation
Remove the front glass (see "front glass removal / installation"
A.
section).
B.
Clean crystal media with mild dish soap, drain, rinse thoroughly and
dry before placing into the tray.
C.
Remove the log set from the media tray (if applicable).
D.
Carefully place crystals or pebbles into the bottom tray on the front of
the appliance as illustrated. Apply an even layer from side to side.
E.
Reinstall the front glass.
Repeat on
opposite side.
Fig. 4-1
www.aflamo.com
Fig. 4-2
7
Tabla de contenido
