Getting Started - DJI Focus Guia Del Usuario

Getting Started

Installing the included lanyard balancing mount on the Remote Controller
1. Remove the original screw from the foot of the mobile device holder.
2. Use the provided screw to secure the lanyard balancing mount, as shown below:
This installation procedure is based on a right-handed configuration.
Place the concave slot of the lanyard balancing mount against the foot of the mobile device holder.
Installation in this user guide is carried out on an Inspire 1 series Remote Controller.
Please install the lanyard balancing mount first when using the harness strap.
Attaching the DJI Remote Controller Accessories Mount
1. Remove the rubber caps on the rear of the Remote Controller.
2. Place the DJI Remote Controller Accessories Mount with its U-shaped end hooking around the Handle Bar of
the Remote Controller. Align the mounting screw holes with the rubber cap holes.
3. Secure the DJI Remote Controller Accessories Mount with the included DJI Remote Controller Mounting
Screws.
4. Loosen the tension adjustment knob then push the sliding rod through the space provided. Adjust the rod so
that it feels comfortable to you, then rotate the adjustment knob clockwise to tighten.
1
2
©
2016 DJI All Rights Reserved. 3