Main Components (Fig.1 ); Product Identification Label (Fig.1 ); Safety Signs (Fig.2 ); Assembly - ST BL 20 Li S Manual Del Usuario

3.2 MAIN COMPONENTS (Fig.1 )

A. Power unit: it drives the rotor.
B. Blower tube: it is the component through
which the air flow is discharged.
C. Handgrip: it makes it possible
to control the machine.
D. Battery (if it is not supplied with the machine,
see chapter 13 "accessories on request"):
device that supplies electric current to the
tool; its specifications and regulations for
use are described in a specific manual.
E. Battery charger (if it is not supplied with
the machine, see chapter 13 "accessories
on request"): device used to recharge the
battery; its specifications and regulations
for use are described in a specific manual.
3.3 PRODUCT IDENTIFICATION
LABEL (Fig.1 )
1. Name and address of Manufacturer
2. Type of machine
3. Sound power level
4. Conformity marking
5. Power supply frequency and voltage
6. Year of manufacture
7. Serial number
8. Article code
9. No load speed
Write the identification data of the
machine in the specific space on the
label on the back of the cover page.
IMPORTANT Quote the information on
the product identification label whenever you
contact an Authorised Service Dealer.
IMPORTANT An example of the
Declaration of Conformity is provided
on the last pages of this manual.

3.4 SAFETY SIGNS (Fig.2 )

The machine has various symbols on it.
Meanings of the symbols:
WARNING! DANGER! The
failure to use this machine
correctly can be hazardous
for oneself and others.
WARNING! Read the
owner's manual before
using the machine.
IMPORTANT Any damaged or illegible
decals must be replaced. Order replacement
decals from an Authorised Service Dealer.

4. ASSEMBLY

IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these instructions to avoid
serious risks or dangers.
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the
assembly should be done on a flat and
stable surface, with enough space for
machine handling and its packaging,
always making use of suitable equipment.
Do not use the machine until all the
instructions provided in the "ASSEMBLY"
section have been carried out.
EN - 5
Use ear protection
devices and goggles.
Do not leave the machine in the
rain (or in damp conditions).
PROJECTION HAZARD!
Pay attention to possible
flying debris projected by the
air flow: which may cause
serious injuries to persons
or damage to objects.
PROJECTION HAZARD! People
or pets must be kept at least 15m
away when using the machine!
Remove the battery before
any inspection, cleaning or
maintenance/adjustment
operation on the machine.