Charging The Battery; English - Konrow KTAB 1004 Guia Del Usuario

1. Inserting a MicroSD
• Switch off the tablet and remove the back cover.
• Insert the memory card in the slot provided for this purpose.
• Then replace the back cover.
CAUTION : Inserting or removing a SIM card and a MicroSD card requires the smartphone to be
completely switched off.

2. Charging the battery

• To charge the battery, plug the USB cable (supplied) into the USB port on your tablet and the
other end into the AC adapter (supplied). Then connect the AC adapter to a power outlet.
• The battery charge icon lights up while charging and indicates the state of charge.
When the battery is fully charged, you can unplug the USB cable from the device and then
from the power outlet.
IMPORTANT:
• The tablet can only be recharged via its USB port.
• The battery should be charged for at least 5-7 hours when charging for the first time.
Note: you can use the device while it is charging. It is then possible that the full
charge time of the battery will be longer.
Precautions to be observed when charging the battery :
• To charge the battery, use only the AC adapter supplied with your device. Do not use any other power
supply or electrical devices.
• The electrical outlet to which the apparatus is connected must be installed near the equipment and
must always be easily accessible.
12

English

• Always wait at least 5 seconds after switching off the device before restarting it.
• Immediately switching off and on the device may damage the electrical circuits.
• Do not disassemble the battery. Do not throw the battery into fire or water. Do not charge the battery
if the ambient temperature exceeds 45 ° C.
• For any repair or to replace the battery, contact a qualified technician.
• Battery life largely depends on how you use it.
Do not expose the battery to temperatures below 0 ° or above 50 °. Its functioning could be altered.
• Strong electromagnetic interference or electrostatic discharge may cause malfunction or loss of data.
If the device is not functioning properly, reset the tablet or unplug the AC adapter from the power
outlet and plug it back in.
3. Turn on / off your tablet
To turn on the tablet, press the On / Off button on the edge of
the tablet for 3 seconds.
If the tablet is on, short press the button to put it into sleep
mode. Press again to exit standby mode.
To turn off the tablet, press the On / Off button for 3 seconds
while a menu appears, then click on the Turn off button and
confirm.
4. Lock / unlock the tablet
To unlock the screen :
• Press the power button on your tablet.
• Touch and drag the unlock icon up to unlock the device.
• You can set the screen lock by adding a password or a drawing to
reproduce when unlocking your Tablet.
CAUTION : Forgetting or losing the password, PIN code or pattern used to
lock the screen permanently blocks your tablet.
In case of forgetfulness or loss, the product warranty will not take effect
for such negligence. Indeed, even a reset cannot solve this problem. As a
precaution, write down your password or your drawing.
PASSWORD : _________________
To lock your device :
• Just press the on / off button.
13