Parts List; Setup Instructions - Polygroup SUMMER WAVES Manual De Usuario

1
Solar
Control Valve
Heater Mat
Pool Size Part # Qty.
P5E000100099 P5E133000E01 P58PF5620P01
x1
Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.
Remove all parts from the packaging box.
Insert the other end of each Transparent
Hose onto the Control Valve.
Power off or directly unplug the pump. Water
will stop flowing.
5
Remove the hose between pump outlet to the
pool inlet. Save for future use.
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.

PARTS LIST

2
3
Hose Adapter Elbow Fitting
Part # Qty. Part # Qty.
P5E19500382A
x2
x2

SETUP INSTRUCTIONS

1
Spread the Solar Heater Mat on a flat
surface. Select a surface that has maximum
exposure to sunlight.
5
Fasten the Transparent Hose ends to the
Elbow Fittings with the cable ties provided.
9
After you turn off your Pump. Install the Service
Plugs onto the fittings of the pool to stop water
from coming out of the pool.
STOP HERE.
13
You will need to determine the
size of your pool and pump fittings .
If Pool and pump fittings are of 1 ½"
diameter: Follow step 15.
MST. Extended operating days and hours during peak season requirements.
4
5
Hose Clamp 1.5" Hose
Part # Qty. Part # Qty.
P5842504500A P58150054W01
x4 x2
2
Insert the Elbow Fitting to the Water Inlet and
Water Outlet on the Mat. Tighten them with the
screw caps.
6
Fasten the Transparent Hose ends to the
Control Value with the cable ties provided.
Some Non-Polygroup Pools use shut-off
®
valves at both the pool inlet fitting and the
pool outlet fitting instead of service plugs.
Close the valves to stop water from
coming out of the pool.
14 If pool and pump fittings are 1 ¼" diameter:
Jump to step 16.
If pool and pump fittings are 1 ½" & threaded:
Jump to step 17.
OWNER'S MANUAL
6
7
Transparent Hose Cable tie
(4X250mm)
Part # Qty. Part # Qty.
P5E3141216C1 P5E044003BK3
x2
3
Insert each Transparent Hose onto
each Elbow Fitting on the mat.
7
Install the Hose Clamps
1.5" Water Hoses then place the hose ends onto
the Control Valve Body. Tighten the Hose Clamps.
The hoses of the Solar Heating Mat are to be
connected between the PUMP OUTLET and the
POOL INLET.
5
Install the remaining Hose Clamps
open ends of the 1.5" Water Hoses connected to
the Solar Heating Mat. Connect one hose 5
from the Solar Heating Mat to the pump outlet
and connect the other hose 5 to the pool inlet
fitting. Tighten the Hose Clamps.
8
Universal adaptor
Part # Qty.
P58003689W05
x4 x2
4
8
over one end of the
4
15
over the
4