Tabla de contenido
Idiomas disponibles
Idiomas disponibles
03. ASSEMBLY INSTRUCTIONS
EN
FITTING THE CARRIER ON THE BICYCLE
10
H2
H3
H2
Place the main body of the frame holder (H) on the front of the bicycle frame, and then place the plate (H3). Note: If they are
cables in this area make sure that they are correctly positioned in the central groove of the plate (H3), (between the clamp
(H2) and the groove of the plate (H3) and are able to move freely).
11
H
H
+
x4
H4
H5
+
x4
H4
H5
K4
Place the washers (H5) in the bolts (H4), and then screw them on to the frame holder (H). Tighten the bolts (H4), with the
allen Key (K4), so that the frame holder (H) is secured but not fully tightened so that, if necessary, you can adjust the height
later. However, note that it should be tight to make it easier to complete the next step. You need to tighten the 4 bolts (H4)
diagonally and in stages. Check the safety of the fasteners regularly.
8
Tabla de contenido
