Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7.
Install both grass bag assemblies, with the
tight mesh sides facing forward, onto the bag
support brackets by inserting the front edge in
first, as shown in Figure 4-15, and setting the
back edge down until it fits into the assembly.
1
Figure 4-15
Installing the Deck Chute
1.
Install the boot rod mount (747-06043) to the
boot using 2 shoulder screws (738-1225) and
2 flangelock nuts (712-04064) from hardware
pack 689-00636. Ensure that the shoulder
screws (738-1225) are installed on the interior
of the boot. See Figure 4-16.
Figure 4-16
2.
With the tractor's discharge chute raised up
and held open (1), install the chute elbow by
placing the chute elbow mounting rod into
the hole provided in either your deck wheel
bracket or chute mounting tab (2), as shown in
Figure 4-17.
1
Figure 4-17
3.
Secure the chute elbow to the deck using a
wing knob (720-04122) from hardware pack
689-00600. See Figure 4-18.
Note: If present, remove the protective cap off
of the mounting stud on the mowing deck as
shown in the upper inset of Figure 4-18.
2
Important! Be certain that the bottom of the
discharge chute is located inside of the lip of the deck
opening, as shown in Figure 4-19.
Installing the Upper Chute Tube
1.
Thread the upper end of the chute tube
securely into the upper chute support. There
are two tabs on the lower inside part of the
upper chute support to allow for secure
threading. See Figure 4-20.
NOTE: The chute tube and upper chute
support are left-hand threaded. Thread
counterclockwise until secure.
2
1
2
Figure 4-18
Figure 4-19
Figure 4-20
2.
Lift by the handles at the bottom of the chute
tube. Slide the chute tube over the chute
elbow mounted on the cutting deck, as shown
in Figure 4-21.
2
1
Figure 4-21
3.
Make sure the connection is secure and there
are no gaps between the chute tube and the
chute elbow.
4.
If open, close the grass catcher cover prior to
mowing.
I
9
nstallatIon
Tabla de contenido
