jbc ADVANCED Serie Manual Del Usuario página 7

ENGLISH
2 Place the component or printed circuit with
the Pick & Place MP 2260 ref. 2260000.
3 When the component is correctly placed, solder
its pins.In the case of integrated circuits of the
Flat Pack type, first solder one pin of every IC
angle to fix it in place in the circuits.
4 Apply Flux FL 9582 ref. 0046565 in pads and
leads.
5 Solder the remaining pins. For this we
recommend to use our soldering irons of the
Advanced series, which are available in two
different models:
Soldering Iron 2210 ref. 2210000 for great
precision tasks, like SMD solders, etc.
Soldering Iron 2245 ref. 2245000 for general
soldering tasks in professional electronics.
These soldering irons have a wide range of
cartridges with different models of tips. The
cartridge 2245-009 and 2245-010 are specially
designed for soldering SMD circuits of the
QFP and PLCC types.
Solder wire with a diameter of between 0.5 and
0.7 mm should be used.
6 Depending on the nature of the component to be
soldered, use soldering paste together with our
hot air station TE 5000, which gives very
accurate air-flow regulation, between 4 and 11
l/min.
6