Assembly Instructions - Master Pro MHP-135-KFA Manual De Usuario E Instrucciones De Funcionamiento

1. Insert axle through holes in wheel support.
2. Slide washer, then spacer onto axle.
3. Slide wheel onto axle with the air valve facing
out and hold in place with the axle nuts (see
Figure 1).
Wheel Support Frame
Tire
Axle Nut
Figure 1
4. Place heater on wheel support and line up
holes on the fuel tank lip.
5. Attach front handle with (2) long screws
(50 mm) and (2) nuts through the first and
second hole from the front on both sides of
the tank lip and wheel support frame and
tighten firmly.
© 2018 Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A POWER SOURCE

ASSEMBLY INSTRUCTIONS

Axle
Spacer
6
6. Attach rear handle with (2) long screws
(50 mm) and (2) nuts through the first second
hole from the rear of the heater on both sides
of the tank lip and wheel support frame and
tighten firmly. Make certain all (4) screws are
secure (see Figure 2).
7. Place Y-bracket over wheel support frame and
handles. Attach with (2) short screws.
8. Repeat step 7 for opposite side.
Figure 2
Kerosene Forced Air Heater User's Manual