RadioShack PRO-89 Inicio Rápido

www.radioshack.com SM
PREPARATION
I B
NSTALLING ATTERIES
1. Press down on the battery compartment cover then
slide the cover in the direction of the arrow to remove
it.
2. If you are using non-
rechargeable batteries, place
them into the black holder, as
indicated by the polarity
symbols (+ and –)
marked on the holder. Or,
if you are using
rechargeable batteries, place
them into the yellow holder as
indicated by the polarity symbols (+
and –) marked on the holder.
3. Place the battery holder into the battery compartment
and replace the cover.
U AC P
SING OWER
Attach a size B Adaptaplug to the AC adapter so the tip
reads positive (+), then insert the Adaptaplug into the
scanner's PWR DC 9V jack. Connect the other end of the
adapter to a standard AC outlet.
U V B P
SING EHICLE ATTERY
Attach a size B Adaptaplug to the DC adapter so the tip
reads positive (+), set the adapter's voltage switch to 9V,
then insert the Adaptaplug into the scanner's PWR DC 9V
jack. Plug the other end of the DC adapter into your
vehicle's cigarette-lighter socket.
RadioShack Corporation
Fort Worth, Texas 76102
Q Q
Q Q
UICK UICK
UICK UICK
PRO-89 200 Channel
VHF/Air/UHF/800MHz Handheld Race Scanner
SQUELCH
Antenna
VOLUME
Display
PWR
DC 9V
C A
ONNECTING AN NTENNA
1. Align the slots around the
antenna's connector with the
tabs on the antenna jack.
OWER
2. Press the antenna down
over the jack and turn the
antenna's base clockwise
until it locks into place.
© 2003 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks used by RadioShack Corporation.
S S
S S
TART TART
TART TART
Refer to your Owner's Manual for complete instructions.
OPERATION
T O S
URNING N THE CANNER
S
AND QUELCH
1. Turn SQUELCH until the indicator points to MIN before
you turn on the scanner.
2. To turn on the scanner, turn VOLUME clockwise until you
hear a hissing sound.
3. Turn SQUELCH clockwise, just until the hissing sound
stops.
4. To turn off the scanner when you finish, turn VOLUME counterclockwise to OFF.
S K F
TORING NOWN REQUENCIES INTO
C
HANNELS
1. Press MAN, enter the channel number (1–200) where you want to store a
frequency, then press PGM.
2. Use the number keys and • to enter the frequency (including the decimal point)
you want to store.
3. Press ENT to store the frequency into the channel.
4. To program the next channel in sequence, press PGM and repeat Steps 2 and 3.
E E
NGLISH NGLISH
20-514 A
/S V
ETTING OLUME
01A03
Printed in China