Pm Value Equivalent Table; Remote Control; Filter Information • Filter Exchange Intervals; Pre-Filter - asecos PURIFIAIR.488 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

3.2. PM VALUE EQUIVALENT TABLE

3.3. REMOTE CONTROL

CR 2032
4. FILTER INFORMATION • FILTER EXCHANGE INTERVALS
4.1. PRE FILTER
Ventilation speed
When the device is switched on, use the "SPEED -" or "SPEED +" buttons to change the level and operating
speed. After changing levels, the motor will only work on the set level, without being influenced by the sensor.
If the device was previously in Auto mode, it will also be ended.
Light sensor in Auto mode
In Auto mode, the device will switch into Sleep mode 2 minutes after the ambient light <5 lx. It will leave
Sleep mode 3 minutes after the ambient light > 5 lx, then continue to work in Auto mode.
Relationship between the levels and PM2.5 data
LEVEL
PM2.5 data
1
0–50
2
51–80
3
81–100
4
101–120
5
121–140
6
141–160
7
161–300
8
301–500
This product is delivered with a remote control that uses button-cell batteries. Please remove the batteries if
the remote control is not in use for a long period of time. The buttons on the remote control match those on
the control panel. The general functions and operating methods are the same.
Note: Remove the battery cover before initial use (for instance with a coin), and remove the protective film
over the batteries. Then replace the cover. Ensure that the "+" symbol is visible on the top of the
batteries.
Filters out large particles such as human hair, animal fur, cotton fibres, etc.
How frequently purification is required is determined by the operating duration, set operating level and degree
of impurities in the air.
Normally, purification should be completed every 2–3 months. Please complete purification in a timely fashi-
on; otherwise, the e ciency of the air purifier may be reduced.
Maintenance
Measures
interval
Every 1–2 months
• Clean the surfaces of the filter with a vacuum cleaner, or wash it in water.
(see above)
• Allow it to dry thoroughly.
Particle concentration
low
normal
high
very high
DE
EN
NL
LED colour
green
blue
FR
yellow
red
ES
17
Tabla de contenido
loading

Tabla de contenido