Front Runner FAJK007 Manual Del Usuario página 6

3 FIT AND SECURE
3.4
3.5
3.6
FAJK007 / FAJK008_REV_A00
4
Pull back the padding around the roll bar
above the rear seats and insert an M8 x
75 Hex Bolt and M8 Large Washer (Items
14 & 15 from FAJK007 box) through the
hole as shown.
From the inside of the vehicle, in the
same position as where you just
inserted the bolt in 3.4, push the Middle
Support Bracket (Item 2LH & 2RH)
through the hole in the roll bar padding
13mm
and loosely fasten it to the roll bar.
Please note that there is a left hand and
right hand bracket. The arrow on the
bracket must point to the rear of the
vehicle.
Refit and fasten the Rear Support Arms
as in 2.3
10mm
NOTE: Use the worm slots to adjust the
height of the rear support brackets.
This will be important to create a
weatherproof Seal.
10mm
6
13mm
© 2020 FRONT RUNNER VEHICLE OUTFITTERS